2
DSP add on board
Clyne edited this page 2 years ago
The DSP add-on board is designed specifically for stmdsp. It provides the necessary circuitry for reading and producing signals, as well as some useful input and output features.
- A status LED to indicate device state and possible faults.
- Two parameter knobs (potentiometers) that allow you to adjust algorithm parameters while the algorithm is running.
- The USB communication port used to connect to the computer.
- Three 3.5mm jacks for input and output signals. These accept signals in the +/- 3.3V range. Their order matches that of the signal pins, described next.
- Input and output signal pins. These also accept +/- 3.3V signals. The upper/north row of pins carry the signals, while the lower/south row is for ground.
Note: The input signal ground pin is isolated to help reduce noise; therefore, a ground reference must always be provided. If the signal generator is being used as an input, connect its ground pin to the input signal ground pin.