1 files changed, 0 insertions, 81 deletions
diff --git a/ChibiOS_16.1.5/community/demos/NRF51/OSHCHIP_V1.0/main.c b/ChibiOS_16.1.5/community/demos/NRF51/OSHCHIP_V1.0/main.c
deleted file mode 100644
index 8e386fb..0000000
--- a/ChibiOS_16.1.5/community/demos/NRF51/OSHCHIP_V1.0/main.c
+++ /dev/null
@@ -1,81 +0,0 @@
-/*
-    Copyright (C) 2015 Fabio Utzig
-
-    Licensed under the Apache License, Version 2.0 (the "License");
-    you may not use this file except in compliance with the License.
-    You may obtain a copy of the License at
-
-        http://www.apache.org/licenses/LICENSE-2.0
-
-    Unless required by applicable law or agreed to in writing, software
-    distributed under the License is distributed on an "AS IS" BASIS,
-    WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
-    See the License for the specific language governing permissions and
-    limitations under the License.
-*/
-
-#include "ch.h"
-#include "hal.h"
-#include "ch_test.h"
-
-static THD_WORKING_AREA(waThread1, 64);
-static THD_FUNCTION(Thread1, arg) {
-  (void)arg;
-
-  uint8_t led = LED_RED;
-  chRegSetThreadName("Blinker");
-
-  while (1) {
-    palClearPad(IOPORT1, led);
-    chThdSleepMilliseconds(100);
-    palSetPad(IOPORT1, led);
-    switch(led) {
-      case LED_RED:
-        led = LED_GREEN;
-        break;
-      case LED_GREEN:
-        led = LED_BLUE;
-        break;
-      case LED_BLUE:
-        led = LED_RED;
-        break;
-    }
-  }
-}
-
-/*
- * Application entry point.
- */
-int main(void) {
-
-  SerialConfig serial_config = {
-    .speed = 38400,
-    .tx_pad = UART_TX,
-    .rx_pad = UART_RX,
-  };
-
-  /*
-   * System initializations.
-   * - HAL initialization, this also initializes the configured device drivers
-   *   and performs the board-specific initializations.
-   * - Kernel initialization, the main() function becomes a thread and the
-   *   RTOS is active.
-   */
-  halInit();
-  chSysInit();
-
-  /*
-   * Activates UART0 using the driver default configuration.
-   */
-  sdStart(&SD1, &serial_config);
-
-  /*
-   * Creates the blinker thread.
-   */
-  chThdCreateStatic(waThread1, sizeof(waThread1), NORMALPRIO, Thread1, NULL);
-
-  test_execute((BaseSequentialStream *)&SD1);
-  while (1) {
-    chThdSleepMilliseconds(500);
-  }
-}