You cannot select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.

2.1 KiB

NoiseCard

NoiseCard is an attempt to build a dead easy tool for monitoring ambient noise levels. The ultra-low-power microcontroller takes periodic decibel measurements while powered on, using blinking LEDs for indication. The circuit requires only a few milliwatts to run, enabling it to run off of direct solar power without a battery (though some large capacitors provide a small reserve).

Ambient noise levels in populated areas, especially North America, can often exceed what is considered safe for our ears, with prolonged exposure leading to lasting impacts on our health. Through a tool like the NoiseCard, people can become more aware of the noisy environments they're living in (and potentially take action to reduce excess noise exposure).

Building the source

You need:

Extract ChibiOS to a folder, edit the Makefile so CHIBIOS points to that folder, then run make.

Flashing the card

You'll need a 6-pin Tag-Connect cable (e.g. TC2030-CTX-NL), compatible programmer, and OpenOCD. Power up the card and run the following command (using the appropriate interface scripts for your programmer):

openocd -f interface/ftdi/olimex-arm-usb-ocd-h.cfg -f interface/ftdi/olimex-arm-jtag-swd.cfg -f target/stm32g0x.cfg -c "program build/ch.hex verify reset exit"

Credits

  • ESP32-I2S-SLM for a starting point with accurate decibel-measuring code.
  • Qfplib for providing optimized floating-point code for the Cortex-M0+ microcontroller.
  • ChibiOS for providing an awesome RTOS and HAL that made firmware porting and device configuration a breeze.